Post #1
Does anyone know if the diameter of the centre section of the exhaust is the same for a Genuine Pug item and a reproduction Factors item?
|
displaying posts 1 to 4 of 4
| Author | Subject: Exaust diameter - Gen v Factors |
 silky
Seasoned Pro  Location: Chelmsford, Essex Registered: 29 Dec 2002 Posts: 3,471 Status: Offline |
|
 Posted 17th Jan 2013 at 12:02
|
|
|
ravemercer
Regular  Location: kent Registered: 18 Jan 2009 Posts: 422 Status: Offline |
Post #2
Gen would be 2 1/4. There's loads of factors they should be the same dia as pug. I had a Hoffmann centre I'm sure that was 2 1/4.  |
|
Posted 17th Jan 2013 at 22:08
|
|
|
JWP EFi
Turbo Legend!  Location: edinburgh Registered: 07 Mar 2010 Posts: 2,163 Status: Offline |
Post #3
overall diameter shouldnt be far off the genuine, its at the bends that will be smaller |
|
Posted 18th Jan 2013 at 23:25
|
|
|
E.L. Jimmy
Newbie  Location: Ireland Registered: 11 Nov 2012 Posts: 36 Status: Offline |
Post #4
ravemercer wrote: Gen would be 2 1/4. There's loads of factors they should be the same dia as pug. I had a Hoffmann centre I'm sure that was 2 1/4. Was the Hoffmann center ok, i know its not top spec but any complaints, might pick one up myself. |
|
Posted 29th Jan 2013 at 18:58
|
|
The Peugeot GTi-6 & Rallye Owners Club - ©2026 all rights reserved.
Please Note: The views and opinions found herein are those of individuals, and not of The Peugeot 306 GTi-6 & Rallye Owners Club or any individuals involved.
No responsibility is taken or assumed for any comments or statements made on, or in relation to, this website. Please see our updated privacy policy. (NEW HOST)