r4ly j
Post #1
Well after much thought and mind changing I'm going to do it.I was thinking of selling the whole but instead I'm going to break.
The car is a T reg bianca white rallye I have owned for over 6 years,
click here = click To see project page.
WHOLE 209BHP ENGINE SETUP
Just going to list things but please ask
Orignal rallye Engine/gearbox 105000ml
Cam covers painted white
Fitted with 264 Newman cams in 2009 (fitted new cam belt at same time)
45 jenvey throttle bodies Black with trumpets
Longmans manifold
Emerald ecu k6 (rev limiter raised to 8000rpm)
Standard injectors
Fuel pressure regulator
Standard exhaust manifold
Loom with all sensors (literally plug straight in)
Selling it with the Longlife stainless straight thru exhaust system so it guarantees bhp as it did on rollers, may not matter but just to be safe. 3" tip.
Will also throw in the custom made air duct which fits perfect round pas pump.
Bodies and remap done in June 2011 and has covered about 1200miles since.
Ran engine with oil cooler fitted since throttle bodies were fitted.
Amazing setup
WILL NOT BREAK ENGINE
Can deliver insured on secure pallet uk main land
£70
SOLD
OPEN TO OFFERS ABOVE £2000
Selling oil cooler mocal thermo plate and pipework (black not braided) NO Matrix
£40 SOLD
Sparco strut brace red £25 SOLD
Peugeot 15" cyclones refurb end by pristine in satin black fitted with toyo r888
Two done about 1000 road miles
Two with about 3mm
near mint wheels, few minor chips no curbing or buckles.
REDUCED £350 bolts and Crome caps
Gti6 calipers
Front calipers red but need redoing, well lubed sliders.
May have some half decent pads to got with.
£70
Ferodo ds3000 front race pads only done 500mile
£90 SOLD
EBC ultamax disc slotted
NO WARP
Bit of surface rust, plenty of life left.
£40 SOLD
Koni coilovers custom made
O/S shock body has been repaired (had bottom turned off on lathe and new bottom welded on, have run them like this on road and track for about 10000mls with no problems, it is good and strong.
Top adjustable( adjustable on car unlike standard Koni shocks.
Can be run real low with shorter spring but will not bottom out because of shortened shafts.
Koni Rear shocks adjustable off car
This setup up has been amazing on many track days
£375 SOLD
OMP bolt in cage in red with door bars Pretty tidy.
REDUCED £375 SOLD
Sparco bucket seat sub frames
Sliders (adjustable)
Not seen these anywhere else but are really good frames that still side low.
£250 pair
NEW ADDED
2x 3 point sparco harnesses black with blue logo, used but good condition.
£100 pair
Front bumper Black gti6 NO FOGS
£45 collection only
Gti6 rad good condition with bottom hose and new O'Ring
£40
17" allesio monza alloys on eBay
click here = click here
Standard gti6 inlet manifold with badge,
£35
Standard gti6 ecu UNLOCKED
£25
Pair of rallye blanks
£10+ postage
All prices are + postage or free for collection from near J10 off m40.
Lots of other stuff, see project build for pics.
Also I can make and supply custom air duct.
For £60+ postage
Posted 1st Apr 2013 at 12:00
