displaying posts 1 to 2 of 2

Author Subject: Getting p**sed off... Gearbox removal
Macallan

Newbie

Location: Vordingborg

Registered: 03 Oct 2021

Posts: 2

Status: Offline

Post #1
Hey guys.

Ive removed all bolts and the clutch arm, and the drive shaft.. Gear levers are off, and all the wiring. Nothing on the outside is holding it Back.

The box is almost of, loose all around, but just wont let go.

Im removing it on the ground on some Jack stands, a hoist and so on.

Any advice? It seems the clutch fork wont let go even though ive remove the pin and the arm. As far as I Ca tell the fork shaft has turned some as I pulled the box away from the engine.

Do i need to pull the engine to get it off?

________________________________________

#puglife
Posted 7th Oct 2021 at 10:37
Macallan

Newbie

Location: Vordingborg

Registered: 03 Oct 2021

Posts: 2

Status: Offline

Post #2
Never mind... I got it . It was stuck on some wires under the inlet manifold.

________________________________________

#puglife
Posted 7th Oct 2021 at 12:00

1996 Volkswagen Golf vr6 highline

  • 2800cc
  • Purple
  • 113,000 miles

£1,300

Location: burton, staffs

All times are GMT. The time is now 18:00

The Peugeot GTi-6 & Rallye Owners Club Ltd - Registered in England & Wales - Reg No: 07410694 - ©2021 all rights reserved.

Please Note : The views and opinions found herein are those of individuals, and not of The Peugeot 306 GTi-6 & Rallye Owners Club Ltd or any individuals involved.
No responsibility is taken or assumed for any comments or statements made on, or in relation to, this website. Please see our updated privacy policy and legal information