Probably of interest to some.. I've reproduced the Peugeot 306 GTi-6 Little Red “6” Badges (old Peugeot Part Number 866503), most notably found on late Phase2 / Phase3 306 GTi-6 doors and hatches. These have been discontinued for some time so we have reproduced them by 3D-printing them in black plastic with a robust red secondary colour face.

They're provided with an uncut patch of foam adhesive tape like factory ones for you to apply to the badge and to your vehicle

£10 posted to forum members

________________________________________

306 rallye reproduction decals (full sets/individual decals) | 306 b-pillar textured vinyl weatherstrips
306 slam panel esso stickers | 306 yellow / orange / pension fund red side door badges
gti6 inlet manifold badges | 306 rear boot badges (p2/p3)
winner of Extraction of toys from prams with outstanding vigour award 2009 [source: gti6 owners club]

Could do many things but they are actually completely smooth anyway, you can't feel them lines, it's just the filament appearance but you don't notice it unless it's right up close in your hand. So, offset against the cost of vapour finishing them it's barely worth it, plus they're PLA rather than ABS

________________________________________

306 rallye reproduction decals (full sets/individual decals) | 306 b-pillar textured vinyl weatherstrips
306 slam panel esso stickers | 306 yellow / orange / pension fund red side door badges
gti6 inlet manifold badges | 306 rear boot badges (p2/p3)
winner of Extraction of toys from prams with outstanding vigour award 2009 [source: gti6 owners club]