displaying posts 1 to 1 of 1

Author Subject: Rebuilt 306 GTi6 rear beam
alastairh

Regular

Location: Kettering

Registered: 14 Jun 2007

Posts: 375

Status: Offline

Post #1
Hello,

Peugeot 306 GTi6 Rebuilt rear beam. I personally have just rebuilt this rear beam after doing many before and has done 0 miles since its rebuild. This consisted of a good low mileage cross member tube that hasn't suffered any previous bearing failiure, new genuine Peugeot inner and outer bearings and seals, used but low mileage and immaculate trailing arm shafts (can provide pictures if required). The torsion bars have been removed completely and freshly greased for future lowering /service. I have set this rear beam back to the original ride height, but should the buyer want to change this, i can alter this at no extra cost. ABS sensors are included.

£300 collected from Kettering, Northants.

Any questions, just send me a message. Can ship, just pm me.

Thanks for looking.

________________________________________

205 GTI6
Primera GT
Xsara VTS
306 GTI6
Posted 3rd May 2012 at 16:47

All times are GMT. The time is now 02:28

The Peugeot GTi-6 & Rallye Owners Club - ©2024 all rights reserved.

Please Note: The views and opinions found herein are those of individuals, and not of The Peugeot 306 GTi-6 & Rallye Owners Club or any individuals involved.
No responsibility is taken or assumed for any comments or statements made on, or in relation to, this website. Please see our updated privacy policy.