hi there

just got hold of this GTI-6, done a P/X with an old VTR for it.

1996 P Plate Phase 1 GTI-6 in Diablo Red
122k
Lowered on Bilstein Suspension
Induction Kit
Bonnet Pins
Tailgate Pins
Sparco Rev Bucket Seats in Black
TRS 4-Point Harnessess in Green
Rear interior removed
Cyclone's resprayed Gunmetal















hope you all like

only have a few plans for it - change of exhaust and further handling improvement (set of 888s to start with)- maybe if i can be bothered a phase 3 front end

will have it on Knockhill this weekend (Sunday)

seats have brackets welded between the bottom of the runners and where the seatbelt rail is meant to be (you can see it in this picture) - there fixed in and are very solid - got to think the seatbelts rail position has to be a strengthened part of the cra (well i'd pressume so) so is a decent enough place to bolt the seats in.



this is how the car was bought, all iv done is fit a cd player to it lol -

yea timing belt and water pump were both done less than a thousand miles ago so no worries there. Its my daily the now doing about 80 miles a day so it'd b even worse if it went then lol. Cool i'll have a look out.

Like the look of that mate, very nice!!

________________________________________

2.1 16v 306 Rallye.

thanks for the comments guys - appreciated

i dont know the exact colour the wheels are unfortunatly - but a colour i do know that works and is good is Honda Cosmic Grey - i done a set of Cyclones this colour for my girlfriends Saxo in Wicked Red - this pic should so how well the colour went

they came with the car - i know whoever bought them paid

no preowned for